Kitbash — Entidade

rcscifi.blogspot.com·há 11 dias

Submarine Kitbash Spaceship part 6

I took one of the primer grey photos into photoshop and messed about until I had something pleasing for a paint scheme. I then looked at the model carefully and thinking about the masking involved wen

rcscifi.blogspot.com·há 23 dias

Submarine Kitbash Spaceship part 5

Grey primer - done. The engine bells are wrapped in cling film to mask them off.A commenter on facebook thought the "spare tire" nurnie is too obviously what it is. It was a part I had that perfectly

rcscifi.blogspot.com·há 24 dias

Submarine Kitbash Spaceship part 4

I believe I have completed the surface detailing phase of the project. The plain white panels are mostly cut from 0.5mm styrene sheet.The rest is a lot of flat panel kit parts and a few bits of evergr

rcscifi.blogspot.com·há cerca de 1 mês

Submarine Kitbash Spaceship Part 3

I added a strip around the back edge to give the rear bulkhead a bit of an inset.The rear bulkhead was then fully detailed out, quite a fiddly process as I had already glued the engine bells in place.

rcscifi.blogspot.com·há cerca de 1 mês

RC Sci Fi: July 2026

A blog about scratch built, toybashed and kitbashed science fiction models featuring original designs of radio controlled vehicles and spaceships.

rcscifi.blogspot.com·há cerca de 1 mês

Submarine Kitbash Spaceship part 2

I made four landing pads from some 1/35 scale Maus tracks and suspension parts. They were drilled to take a short piece of brass rod which was then inserted and glued to the bottom of the hull. I also

rcscifi.blogspot.com·há cerca de 2 meses

Submarine Kitbash Spaceship part 1

I came across this image of a kitbashed spaceship on Facebook made from the two halves of a submarine Plastic model kit. The modeller was Tony Murray https://www.facebook.com/groups/2043682082594379/p

thedarkoak.blogspot.com·há 11 meses

The Dark Oak: października 2025

Post udostępniony przez The Dark Oak (@the_dark_oak) Well, what's been happening, I'm actually managing to publish something! Today, a model that came about by chance. Those of you who follow me on